Spare Parts - Grizzly ARV 4038 Lion-Set Mode D'emploi

GB
Recharger .................................. DYMA82
Voltage
input .......................220-240 V~; 50 Hz
Voltage/
Output ............................... 40 V
Protection class ...............................
Protection category ........................ IP20
* The effective service life of a fully charged bat-
tery under load depends on the operation and the
stress during cutting.
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be
carried out in the course of further deve-
lopment without notice.
All dimensions, references and informati-
on of this instruction manual are therefore
without guarantee. Legal claims, which
are made on the basis of the instruction
manual, cannot thus be considered as
valid

Spare parts

Spare parts and accessories can be obtained at
If you do not have internet access, please contact the Service Centre via telephone
(see "Grizzly Service-Center"). Please have the order number mentioned below ready.
Battery ...............................................................................................................80001176
Battery charger ................................................................................................ 80001096
Quick charger ......................... ........................................................................ 80001097
Collection bag ................................................................................................... 91097028
Aerator drum..................................................................................................... 91097020
34
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another. The
; 1 A stated vibration emission value may also
II be used for a preliminary exposure as-
sessment.
www.grizzly-service.eu
Warning:
The vibration emission value may
differ during actual use of the po-
wer tool from the stated value de-
pending on the manner in which the
power tool is used.
Safety precautions aimed at protec-
ting the user should be based on
estimated exposure under actual
usage conditions (all parts of the
operating cycle are to be conside-
red, including, for example, times
during which the power tool is tur-
ned off and times when the tool is
turned on but is running idle).