Insert/Remove Battery; Charge Battery - Grizzly ARV 4038 Lion-Set Mode D'emploi

GB
- Cordless chainsaw
AKS 4035 Lion
- Cordless leaf blower
ALS 4025 Lion
- Cordless lawnmower
ARM 4046 A-Lion Set
- Cordless lawnmower
ARM 4038 Lion Set
- Cordless lawnmower
ARM 4051 A Lion Set
Otherwise, please contact the
Service Centre (cf. Spare parts/
accessories). You can order the
rechargeable battery and the corre-
sponding charger from them.
Do not expose the battery to
extreme conditions such as heat
or impact. Risk of injury from
escaping electrolytic solution!
After eye/skin contact, rinse the
affected areas with water or a
neutraliser and consult a doctor.
Charge the battery in a dry
room only. Prior to attaching the
charger, check that the battery's
outer surface is clean and dry.
There is a risk of injury due to
electric shock.
Only use the charger from the packa-
ge to charge the battery.
• The rechargeable battery reaches its
full capacity only after it was charged
several times.
• Charge the battery before the first time
of use. Do not briefly charge the battery
several time in a row.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
28
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.

Insert/remove battery

1. To insert the battery (11) into
the device, open the battery
cover (7) and insert the battery
(11) into the device. It locks into
place audibly.
2. To remove the rechargeable
battery from the device, open
the battery cover (7), press the
unlock button (11a) upward and
pull out the rechargeable battery.

Charge battery

Allow a freshly charged battery
(11) to cool down for approx. 15
minutes before inserting it into the
battery charger (15).
1. Remove the battery (11) from
the appliance, as necessary.
2. Insert the battery (11) in the
charging compartment of the
battery charger (15). It will au-
dibly snap in.
3. Plug the battery charger (15)
into a mains outlet.
4. When the battery is fully rechar-
ged unplug the battery charger
(15) from the mains.
5. Press the release button (
11a) on the battery (11) and pull
the battery out of the battery
charger (15).
B