Working With The Implement; Exchanging The Cylinder - Grizzly ARV 4038 Lion-Set Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
Alternatively when the batters is
installed:
Press the POWER button
of the charge level indica-
tor (12) on the upper
handlebar. The charge le-
vel of the battery is indica-
ted by illumination of the
corresponding LED light.

Working with the implement

To maintain a well cared-for lawn it should
be aerated every 4 to 6 weeks.
Verticuting is a more intensive intervention
than aerating and should only be carried out
once a year, the best time being in spring af-
ter the lawn has been mown for the fi rst time.
When working on slopes always
proceed across the slope. Be
particularly careful when wal-
king backwards and pulling the
implement. Danger of stumbling!
The shorter the grass, the better
the lawn can be treated. Fur-
thermore, the implement is less
stressed and the service life of the
cylinder is prolonged.
• The implement can be operated with or
without the collection bag.
Recommendation: Work with the coll-
ection bag for aerating and without the
collection bag for verticuting.
• To ensure that the collision guard fl ap
closes properly, remove any earth that
may have collected on the collision
guard springs and/or the housing. When
working without the bag, check that the
collision guard fl ap is tightly closed.
• Mow the lawn to the required grass height.
• Do not use the scarifi er in long grass.
It may otherwise wind around the sca-
rifi er blade and result in damage to the
equipment.
• Select the appropriate working or read-
justment position (in the event of cylin-
der wear) so that the implement is not
overloaded.
• Guide the implement at a walking pace
down lanes that are as straight as pos-
sible. To ensure uninterrupted aerating
or verticuting the individual lanes should
always overlap by a few centimetres.
Dwelling too long at the same place
while the implement is running can da-
mage the grass sward.
Switch off the device after doing any
work and when transporting the de-
vice, pull the contact chip (
wait for the drum to come to a stop.
• Adjust the transport position 0 setting
(see "Setting the Working Position")
when transporting the implement.
• Lift the implement to transport it over
steps and sensitive surfaces (e.g. tiles).
• Always clean the implement after each use
(see "Cleaning, Maintenance, Storage").
• After having treated lawns with dense moss
growth, it is advisable to reseed the lawn
so that it can regenerate itself quicker.

Exchanging the cylinder

Switch off the device, pull the con-
tact chip (
drum to come to a stop.
Wear gloves when handling the
cylinder.
H
1. Turn the implement over.
2. Release the fastening screw
(22) and fold the bearing cover
(23) away.
E
13) and
E
13) and wait for the
GB
31

Publicité

Table des Matières
loading

Table des Matières