Cooling Of Cylinder - Struers ProntoPress-20 Mode D'emploi

Cooling of Cylinder

To start cooling:
To stop cooling:
ProntoPress-20
Instruction Manual
The mounting cylinder can be cooled without pressure on. This
can be performed with the top closure removed or in place. This
feature can be used for supplementary cooling, if, for example, an
ongoing mounting process should be stopped.
Go to the SELECT METHOD GROUP MENU:
SELECT METHOD GROUP
1. STRUERS
3. GROUP NUMBER 3
F1:CONFIG. F3:MAN. FUNC.
If the heading in the display is different, press Esc until the
Select Method Group Menu appears.
Press F3 to activate the manual
F3
functions.
D
State: OFF
Pre-set Temperature:
Actual Temperature:
F1:START HEATING
D
mO
Press MENU UP/DOWN
mN to the display for cooling:
D
State: OFF
Cooling Time:
Cooling Rate:
F1:START COOLING
Adjust the cooling time and cooling rate to the desired values.
See Method Edit.
If the cooling time is set to 0:00, the cooling time will auto-
matically count from the maximum value: 15:00, when the
cooling is started.
Press F1:START COOLING to start
F1
cooling.
Press F1:STOP COOLING to stop
F1
cooling.
The cooling is automatically switched off, if manual heating is
selected or if a mounting process is started.
2. GROUP NUMBER 2
4. GROUP NUMBER 4
F4:RENAME
HEATING OF CYLINDER
50 °C
25 °C
mON
to come
COOLING OF CYLINDER
4:30
HIGH
39