Assembling The Mounting Unit; Removing The Cover; Installing The Lower Ram; Installing The Mounting Unit - Struers LaboPress-3 Mode D'emploi

Assembling the Mounting Unit

Removing the Cover

Installing the Lower Ram

Installing the Mounting Unit

LaboPress-3
Instruction Manual
Press the catch (pos. 4).
Press gently on both sides of the cover to release it, and lift it
up.
Catch
Place the lower ram on the top of the piston rod.
Turn the lower ram so that the holes in the axle journal on
top of the rod and ram line up, and insert the piston pin.
Make sure that the ends of the pin do not protrude.
The axle journal is part of the machine's safety mechanism to protect
against damage to the machine. Please see: Maintenance. If it breaks, it
must only be replaced with a Struers replacement part or the safety
Mounting cylinder
Fixation screw
Upper quick coupling for cooling water
Lower quick coupling for cooling water
Plug
Do not operate the machine whilst installing the mounting unit
IMPORTANT
mechanism may not function.
IMPORTANT
5