Technical Details; Material Classification And Choice Of Tools - Promac SY-315 Mode D'emploi

Grease the hinge pin for the head assembly.
10.4 Semi annual maintenance
- Check the passage of the equipotential bonding
protection circuit.
- See chapter 10.7 reduction unit.
10.5 Oils for lubricating coolant
Considering the vast range of products on the market, the
user can choose the one most suited to his own
requirements, using as reference the type SHELL LUTEM
OIL ECO.
THE MINIMUM PERCENTAGE OF OIL DILUTED IN
WATER IS 8~10%.
We recommend the following products:
Art. No: 9179 coolant 5kg
Art. No: 100385 way lube oil 1lt
Art No: 100382 gear box oil 1lt
10.6 Oil disposal
Oil products must be disposed in a proper manner
following local regulations (see chapter 4.6).
10.7 Reduction gearbox
The gear box oil has to be changed periodically. The first
oil change is to be carried out after 6 months, and then
after that once a year.
Change the oil as follows:
- Disconnect the machine from the mains supply.
- Put the saw blade in a vertical position.
- Unscrew the lever from the gear head
- Remove the oil drain screw (A) and allow the oil to drain
off into a container.
Replace the screw (A) once all the oil has drained off.
- Move the saw arm into a raised position.
SY-315 / SY-315L
Pour fresh oil (item 100382) into the filler hole (thread hole
on lever) - quantity 0.3 l.
- Fit and tighten the lever.
10.8 Special Maintenance
Special maintenance operations must be carried out by
skilled personnel. However, we advice contacting dealer
and/or importer the term special maintenance also covers the
resetting of protection and safety equipment and devices.

11. Technical details

11.1 Table of cutting and technical details
Cutting capacity in mm
90° 50
45° 50
Power supply
Main motor
Cooling pump
Saw blade dimension
Blade speed SY-315
Blade speed SY-315L
Vice opening max.
Coolant tank
Machine dimensions (LxWxH) 1020 x 990 x 1830 mm
Machine weight with stand
11.2 Noise emission
Acoustic pressure level (EN ISO 11202):
Idling
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.

12. Material classification and choice of tools

12.1 Rounding of teeth
A carefully broken in blade lasts much longer and gives
better performance.
14
100 82x82 110x70
90 80x80 85x70
3~400V, PE, 50Hz
1,3 kW
0,1 kW
Ø315 / Ø32 mm
44/88 rpm
22/44 rpm
120 mm
170 kg
Lpa 70,0 dB(A)
5 lt