Technical Specification; General Safety Instructions - Promac 349V2 Manuel De L'utilisateur

UK-English

Technical Specification

Attention: Please choose proper power source, voltage and frequency that are shown in the label for your
metal band saw.
Metal band saw
Motor Power
Saw Blade
Saw Blade Teeth
Cutting Capacity at Square Material
Cutting Capacity at circular Material
Cutting Angle Adjustment
Blade Speed
SAFETY
WARNING:
To avoid electrical hazards, fire hazards, or damage to the tool, use proper circuit protection.
Use a separate electrical circuit for your tools. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.

GENERAL SAFETY INSTRUCTIONS

WARNING:
Read carefully these Operating Instructions. Familiarise with the controls and proper use of the
machine. Keep the Operating Instructions for future reference. The warning labels with instructions attached to the
machine provide important information on safe operation.
1. READ and become familiar with the entire Operator's Manual. LEARN the tool's application, limitations and possible
hazards.
2. REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and adjusting wrenches are
removed from the tool before turning ON.
3. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
4. DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in damp or wet locations, or expose them to rain.
Keep work area well lighted.
5. KEEP CHILDREN AWAY. All visitors should be kept at a safe distance from work area.
6. MAKE WORKSHOP CHILDPROOF with padlocks.
7. DON'T FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
8. USE THE RIGHT TOOL. Do not force tool or attachment to do a job for which it was not designed.
9. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension cord,
be sure to use one heavy enough to carry the current your product will draw. An undersized cord will result in a drop in
line voltage and in loss of power that will cause the tool to overheat.
10. WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry that may get
caught in moving parts. Non-slip footwear is recommended. Wear protective hair covering to contain long hair.
11. ALWAYS WEAR EYE PROTECTION. Wear goggles for protection against projected chips.
349V2
400 W S6 30%
1435 X 12.7 X 0.65 mm
8/12 teeth per inch
90 º 127 X 125 mm
45 º 80x100mm
90 º 125 mm
45 º 76mm
0—60 º
38-80 m/min
13