Promac SY-315 Mode D'emploi page 9

Plug in the control handle cable into the open socket (M).
Use a wrench to screw in the cable connecter nut (N).
Attach the support roller (P) on the left side of the
machine base.
- Align the 2 slots (O) in the base of the support roller with
the matching screw holes on the base of the machine.
- Adjust the height of the support roller (P). Place a level
across the mouth of the vice and support roller. If a long
level in not available, use a straight bar or piece of
material then place a small level on top. Raise or lower
the support roller until level.
- Secure the 2 bolts (O).
Insert the thread end of the long rod (R) into the side of
the vice.
- Turn the long rod clockwise until snug.
- Use a wrench to turn the hex nut M12 (Q) on the long
rod, so that bar stop unit is secure.
SY-315 / SY-315L
Attach the cover plate (S) to machine stand.
- Place plate next to the hole at the base of the machine
stand.
- Align the plate holes and the stand holes.
- Use 4 screws M5x6 to secure onto place.
Apply an M6 washer to each of 2 M6x20 screws (U).
Secure pump (X) to tank (T) with prepared screws (U).
Place the hose clamp (V) onto the flow tube (W).
Connect the flow tube (W) to the hose connector (V).
Use a flat head screwdriver to tighten the hose clamp (V).
Attach the coolant system:
- Attach the coolant pump (X) with two screws M6x20 (U)
onto the coolant tank (T).
- Connect the flow tube (W) by using two hose clamps (V) to
the pump and hose connector.
9