Technical Characteristics; Noise Emission - Promac SX-823DGVI Mode D'emploi

9. Technical characteristics

9.1 Table of cutting capacity and technical details
SX-823DGVI
Cutting capacity
Electric motor-blade rotation
Flywheel diameter
Blade dimensions
Blade speed cutting
Opening vice
Saw frame tilting
Working table height
Weight
SX-827DGVI
Cutting capacity
Electric motor-blade rotation
Flywheel diameter
Blade dimensions
Blade speed cutting
Opening vice
Saw frame tilting
Working table height
Weight

9.2 Noise emission

Acoustic pressure level (EN 11202):
Idling
Operating
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
1.1kW
295mm
27x0,9x2460mm
20~85 m/min
260mm
40°
900mm
280 kg
1.5kW
380mm
27x0,9x3160mm
20~85 m/min
355mm
40°
900mm
360 kg
Lpa 71,0 dB(A)
Lpa 83,8 dB(A)
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
10. Choosing the saw band
Choose a toothing that is appropriate to the workpiece being
processed. Ideally, at least 3 teeth should be in action at the
same time.
The toothing should not be smaller than necessary, as the
cutting speed is reduced if there are too many small teeth
working on the workpiece simultaneously, which causes the
saw band to wear more quickly, and makes the cuts crooked
and distorts them.
The following table shows the approximate toothing of the
saw bands for a specific material thickness. For further
information please contact your saw band dealer.
Comments
10/14 toothing provides good cutting results for thin-walled
pipes and profiles.
13