Tips And Advice On Installation - SOMFY S&SO-RS100 io Notice

Operate the roller shutter and allow it to stop
3)
automatically at the upper end limit (if stops) or lower
end limit (if rigid links).
my,
Press for ≈ 2 s, until there is back and forth
4)
movement by the roller shutter.
The setting for the first end limit is confirmed.
→
Move the roller shutter to the desired lower end
5)
limit (no rigid links) or upper limit (no stops).
my
Press , for ≈ 2 s, until there are two back and
6)
forth movements by the roller shutter.
The setting for the second end limit is confirmed.
→
The settings for the end limits are programmed.
→
The drive enters programming mode for ≈ 10 min. if no control point is programmed.
→
The procedure for modifying the end limit settings is identical to the initial setting procedure.
To modify the settings at a later time, repeat step 2
Step 3: Programming the Somfy io-homecontrol
If the drive is no longer in programming mode, repeat Step 1 again, before performing Step 3.
The drive is in programming mode:
Briefly press the PROG button on the Somfy
-
io-homecontrol local control point you want to
®
programme:
The roller shutter moves back and forth: this
→
control point has been programmed in the drive.
Some control points have an ON/OFF button. To activate them, press the ON/OFF button at the
back of the control point.

2.4. TIPS AND ADVICE ON INSTALLATION

2.4.1. Questions on the S&SO-RS100 io?
Observations
The roller shutter does
not operate.
The roller shutter makes
2 brief movements
before executing the
Λ and V orders and
functions at slow speed.
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
Possible causes
The wiring is incorrect.
The overheating protection on the drive
has been activated. The temperature
protection of the S&SO-RS100 io takes
several parameters into account and
can therefore be triggered to protect
it even though the tube temperature
is not high.
The io-homecontrol control point
®
battery is low.
The control point is not compatible.
The io-homecontrol control point used
®
is not programmed in the drive.
The end limit setting in manual or
semi-automatic mode was interrupted.
3)
5)
b .
local control point
®
PROG. 0.5 S
Check the wiring and modify as required.
Wait for a few minutes.
Check the battery and replace it as required.
Contact a Somfy representative.
Use a programmed control point or program this
control point.
If setting in manual or semi-automatic mode is
required: repeat the setting procedure
a
(see Step 2 or Step 2
Otherwise move the roller shutter once to the upper
end limit and once to the lower end limit to return to
normal operating mode.
EN
4)
2 S
6)
2 S
X 2
Solutions
b
).
Non contractual images.
31