Tips And Advice On Installation - SOMFY Sonesse 28 WireFree RTS Li-ion Notice

Sonesse 28 WireFree RTS / Sonesse ULTRA 30 WireFree RTS
2.3.5. Activate/Deactivate "RTS" radio technology when control point is temporarily
preprogrammed (not paired) to the driven product.
This function is used to deactivate the radio transmission to
save the battery life during shipment, or when the product will
not be used for an extended amount of time (eg: storage).
1) To deactivate the "RTS" Radio Technology Somfy, press the
UP, MY and DOWN buttons simultaneously, until the driven
product briefly moves Up and Down once and green LED
blinks 5 times.
2) To activate the "RTS" Radio Technology Somfy, briefly press the motor head programming button,
the driven product briefly moves Up and Down twice.
2.3.6. Recording "Pairing" the control point
A er recording the end limits:
Briefly press the control point programming button. The driven
product will briefly move Up and Down to confirm pairing.
The control point is recorded "paired" to driven product and
green LED blinks 5 times.

2.4. TIPS AND ADVICE ON INSTALLATION

2.4.1. Questions about the drive?
Observations
The driven product
does not operate.
The driven product
stops too soon.
Copyright 2017 - 2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
Possible causes
Drive battery is low and requires
charge. Red LED blinks 5 times
when any button of a paired
control point is pressed.
The control point battery is low.
LED doesn't light when any
button of a paired control point is
pressed.
The control point is not compatible
or not programmed. LED doesn't
light when any button of control
point is pressed.
An obstacle hinders the movement
of the driven product. The Red LED
lights fixed on.
Drive position is out of the end
limits. Red LED blinks 2 times
intermittently and continually.
Motor is neither set nor paired.
Orange LED lights fixed on.
The thermal protection has
activated. LED blinks red
continuously
The end limits are incorrectly set
The driven product has exceeded
recommended weight limit.
Battery is low. Red LED blinks 5
times when any button of a paired
control point is pressed.
1
PROG.
Solutions
Plug in the charger.
Check the battery and replace it as
required.
Check the compatibility or pair the
control point as required referring
to 3.7.1. Adding/Deleting Control
point chapter.
Remove the obstacle.
Proceed to section «Setting the end
limits»
Proceed to section «Commissioning»
Wait for the drive to cool down (LED
will switch o )
Reset the end limits.
Replace driven product.
Charge the battery.
EN
2
2x
5