Tips And Advice On Installation - SOMFY Maestria WT Notice Originale

EN

2. 4. TIPS AND ADVICE ON INSTALLATION

2. 4. 1. Re-setting the end limits
The following steps apply only for end limits that are set manually
READJUSTMENT OF END LIMITS SET IN MANUAL MODE
Re-setting the upper end limit
In this mode, there is a response time between the activation of the control point and the reaction
by the application.
Place the driven product at its upper end limit.
1)
Press the "Up" button for approximately 5 seconds.
2)
Wait for 2 seconds.
3)
Press the "Up" button until the driven product moves up and
4)
down.
Repeat steps 3) and 4) four times
5)
The last up and down movement is brief.
•
Place the driven product in the desired upper end limit
6)
position.
Briefly press the "Down" button.
7)
If the driven product reacts, repeat step 6).
Wait for 2 seconds.
8)
Press the "Down" button until the driven product moves up
9)
and down briefly to validate the setting.
Re-setting the lower end limit
In this mode, there is a response time between the activation of the control point and the reaction
by the application.
Place the driven product at its lower end limit.
1)
Press the "Down" button for approximately 5 seconds.
2)
Wait for 2 seconds.
3)
Press the "Down" button until the driven product moves up
4)
and down.
Repeat steps 3) and 4) four times
5)
The last up and down movement is brief.
•
Place the driven product in the desired lower end limit
6)
position.
Briefly press the "Up" button.
7)
If the driven product reacts, repeat step 6).
Wait for 2 seconds.
8)
Press the "Up" button until the driven product moves up and
9)
down briefly to validate the setting.
Images not contractually binding
48
1) 2)
5 s
4) 5)
6) 7)
8) 9)
2 s
1) 2)
4) 5)
6) 7)
8) 9)
2 s
Copyright © 2016 Somfy SAS. All rights reserved.
3)
2 s
[ Step 3
+
Step 4 ]
x 4
0.5 s
3)
5 s
2 s
[ Step 3
+
Step 4 ]
x 4
0.5 s