Tips And Advice On Installation - SOMFY Orea WT Notice Originale

2. 4. TIPS AND ADVICE ON INSTALLATION

2. 4. 1. Questions about the Orea WT?
Problems Possible causes
The awning The wiring is incorrect.
rotates in the
wrong direction.
The awning does The wiring is incorrect.
not operate.
The overheating protection on
the drive has been activated.
The control point is
not compatible.
The awning stops The awning is encountering
too soon. friction when it moves: rubbing
on the guide rails and cassette,
interference between the
winding tube and the drive, etc.
The drive has been installed in
a new awning.
The awning does 7KH ¿[LQJV XVHG
not stop at the are unsuitable.
lower end limit.
The awning does The system for stopping the
not stop at the awning in the upper position
upper end limit. is unsuitable.
2. 4. 2. Re-setting the end limits
1
Use universal adjusting cable 9015971 (follow the instructions in the corresponding
manual for connection), or use a non-locking double push-button switch.
Re-setting the lower end limit
,Q WKLV PRGH WKHUH LV D UHVSRQVH WLPH EHWZHHQ WKH DFWLYDWLRQ RI WKH FRQWURO SRLQW DQG WKH
reaction by the end product.
Place the awning at its lower end limit.
1)
3UHVV WKH 'RZQ EXWWRQ IRU DSSUR[LPDWHO\  VHFRQGV
2)
Wait for 2 seconds.
3)
Press the "Down" button until the awning moves back
4)
and forth.
Repeat steps 3 and 4 four times.
5)
The last back and forth movement is brief.
‡
Place the awning in the desired lower end limit
6)
position.
%ULHÀ\ SUHVV WKH 8S EXWWRQ
7)
,I WKH DZQLQJ UHDFWV UHSHDW VWHS 
Wait for 2 seconds.
8)
Press the "Up" button until the awning moves back
9)
and forth.
The new lower end limit position is programmed.
Copyright © 2005 - 2014 Somfy SAS. All rights reserved.
Solutions
Check the wiring and modify as required.
Check the wiring and modify as required.
Wait for the drive to cool down.
Check the compatibility and replace the
control point as required.
Check the installation of the awning and
adjust any rubbing points.
,I WKH SUREOHP SHUVLVWV UHVWRUH WKH GULYH
WR LWV RULJLQDO FRQ¿JXUDWLRQ
Restore the drive to its original
FRQ¿JXUDWLRQ VHH VHFWLRQ HQWLWOHG
5HVWRULQJ WKH RULJLQDO FRQ¿JXUDWLRQ 
Check that the awning is secured to the
winding tube with rigid links.
&KHFN WKDW WKH DZQLQJ LV ¿WWHG ZLWK
VWRSV VFUHZHG WR WKH HQG VODW ¿[HG RU
removable stops incorporated into the
guide rails or an end slat that acts as
a stop.
1)
4)
6)
8)
2 s
Non contractual images
EN
2) 3)
5 s
2 s
5)
[Step 3
+
Step 4]
x 4
7)
0.5 s
9)
37