Problems And Solutions - EUROM Fireball 20T Manuel D'utilisation

Problems And Solutions

The heater burns but switches off after a short period
The light blinks, display shows E1
 Incorrect pump pressure
 Dirty air filter
 Dirty fuel filter
 Nozzle dirty
 Photoelectric cell lens dirty
 Photoelectric
cell
correctly
 Photoelectric cell defective
 Bad electrical connection between
photo cell and PCB
The heater is not working or the motor runs for a short time only.
The light blinks, display shows E2
 No fuel in the tank
 Incorrect pump pressure
 Spark plug dirty or plug opening
incorrect
 Dirty fuel filter
 Nozzle dirty
 Dirt in fuel or tank
 Bad electrical connection between
transformer and operating panel
 Ignition wire not connected to spark
plug
 Broken ignition
The fan does not work but the heater comes on.
The light blinks or stays on and the display shows E1 or E2
 Thermostat settings too low
 Electrical connection between the
operating panel and motor is broken
Bad combustion or excess formation of soot
 Dirty inlet, outlet or lint filter
 Dirty fuel filter
 Bad fuel quality
 Pressure is too high or low
 Check pump pressure and adjust if
necessary
 Clean/replace air filter
 Clean/replace fuel filter
 Clean/replace nozzle
 Clean the lens
not installed
 Install correctly
 Check and replace photoelectric cell
if necessary
 Check
repair where necessary
 Add fuel
 Adjust pump pressure
 Clean spark plug, adjust or replace
 Clean/replace fuel filter
 Clean/replace nozzle
 Replace fuel and clean tank with
paraffin
 Check all connections, see wiring
diagram
 Connect the ignition cable to the
spark plug
 Replace the ignition
 Set thermostat higher
 Check all electrical connections
 Clean or replace filters
 Clean or replace filter
 Do not use dirty or old fuel
 Set the right setting
43
electrical connection and