EUROM Fireball 20T Manuel D'utilisation page 33

Générateurs d'air chaud - fioul ou kérosène
Masquer les pouces Voir aussi pour Fireball 20T:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Only have your heater repaired by a qualified person: the heater fulfils safety
requirements. That is why repairs must only be carried out by a suitable, qualified
individual, using original parts. Deviations from this regulation will invalidate the
guarantee and the supplier and manufacturer will no longer be liable for any
consequences.
And also:
 Every time you use it, check that the heater is in good condition and is working
properly. Have damaged parts repaired or replaced immediately. Never use a
damaged heater.
 Only connect the heater to a socket which corresponds to the voltage and
frequency that is stated on the heater's specification plate. Only use an earthed,
3-pin socket. If you have to use an extension cable, make sure it is 3-wire and of
the appropriate thickness!
 Only use paraffin or diesel of a good quality in your heater, in accordance with the
instructions in this booklet. NEVER use fuel such as petrol, benzene, used oil,
naphtha, alcohol, turpentine, thinner, paint thinners or other oil compounds or
flammable liquids in the heater. This may lead to a risk of explosion.
 Always position the heater on a flat, stable and horizontal surface. Stellen Sie den
Heizer stets auf eine flache, stabile und ebene Unterlage. This heater is not
suitable for use on a wooden or any other flammable surface. If necessary, place
inflammable material which is at least 26 mm thick under the heater. This must
extend one metre from the heater at the back and sides and at least 2.5 metres in
front.
 Keep the front of the heater at least 2.5 metres from any flammable materials
such as wood, plastic, paper, tent cloth, etc and the back and upper sides at least
125 cm from this type of material. Stow tent cloth/plastic etc or ensure there is
additional distance between this type of material and the heater (see distances
indicated)..
 Do not use the heater in the vicinity of paint, flammable materials, liquids, gases
or pressurised gas pipes.
 Do not use the heater in an enclosed space, living area, ground floor, cellar or
space under ground level.
 Do not start the heater if the combustion chamber chamber is not hot.
 Do not start the heater if too much fuel has gathered in the combustion chamber.
 Do not allow untrained, inexperienced people to operate the heater and do not
allow it to be operated unless all covers, lids and so on have been correctly
installed. People with respiratory problems must first consult a doctor before using
the heater.
 Never leave a working heater unsupervised but switch it off when you leave the
workspace. Give it time to cool down before you remove the plug from the socket.
Do not switch the heater off by removing the plug from the socket; always use the
on/off switch. Always remove the plug from the socket if the heater is not in use.
 Make sure, after use, that the heater has been switched off properly and store it in
a safe and dry environment out of the reach of children. Verwijder de brandstof.
 Do not replenish the fuel when the heater is working or is still hot. Switch it off,
remove the plug from the socket and leave to cool. Replenish fuel outdoors and
make sure that there are no naked flames nearby. Do not overfill the fuel tank
33

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fireball 37t

Table des Matières