Instructions For Use - EUROM Fireball 20T Manuel D'utilisation

triggered, it may mean that your heater needs to be serviced.
If the temperature has dropped to under the reset-temperature, the heater can be
used again.
Electrical system safeguard: The heater's electrical system is protected by a safety
fuse. The fuse safeguards the electrical components against damage. If the heater
does not work, first check the fuse and replace it with a similar fuse if necessary.
Flame control: The heater uses a photoelectric cell to keep an eye on the
combustion chamber when the heater is operating. It will switch the heater off if the
flame goes out.

Instructions for use

on the warning stickers and in the instruction booklet
Fueling
 Place the heater on a stable, flat and horizontal surface.
 Remove the tank cap.
 Fill the tank with clean paraffin or diesel till the fuel gauge points "F".
 Replace the cap on the tank.
Note: Never replenish fuel if the heater is on or is still hot. Always wait until the
heater has cooled down before topping up the fuel.
Never fill up the fuel in an enclosed area; always do it outdoors.
Do not overfill the heater and remove any spilt fuel immediately and carefully, before
using the heater.
Starting the heater:
 Before use, check the device and the electrical cable, plug and socket for any
damage or wear and tear and do not use if you discover any problems. This
heater is fitted with a standard 250V - 16A plug. Choose an impact-resistant type
if it ever needs replacing. The electricity network to which the heater is connected
must be equipped with an earth leakage circuit breaker (30 mA) and the socket
Read all instructions and warnings
and check the heater for defects!
38