EUROM Fireball 20T Manuel D'utilisation page 39

must be earthed. Repairs to the electrical system must always be carried out by a
qualified electrician!
 Before use, always check that the socket is of the correct voltage, is earthed, has
an adequate fuse (5A) and forms part of a mains network with an earth leakage
circuit breaker.
 If you have to use an extension cable, make sure that the cable is of a suitable
width which is appropriate for the voltage and amperage.
 Make sure the ON/OFF-switch is on
'OFF'-position.
 Now insert the plug into an appropriate
and earthed socket.
 Set the thermostat to the desired
setting (Min. 5ºC – max. 45ºC).
 Press the ON/OFF switch to ON. The
light and the display will come on and
the heater will start.
Important: Ignite the heater for the first time outdoors and then let it run for at least
10 minutes. Oil and similar substances used during the manufacturing process will be
burnt off and may produce toxic gases.
If the heater won't start, the thermostat regulator may be set too low. Turn the
thermostat button up and try again. If it still doesn't start, set the switch to OFF and
then switch back to ON.
Note: the heater's most important electrical components are protected by a fuse. If
the display and the light fail to come on even though there is power to the heater,
check the fuse before anything else.
Stopping the heater:
 Press the ON/OFF switch to OFF and remove the plug from the socket.
Restarting the heater:
 Wait at least 10 seconds after you have switched the heater off.
 Repeat the steps set out under: 'Starting the heater'.
ALWAYS ENSURE THERE IS ADEQUATE VENTILATION!
At least 2 x 2,800 cm² per 100,000 BTU/hr
Fireball 22T: 0.7 x 2800 = 1960 cm² so: 2 openings of 40 x 50 cm.
Fireball 37T: 1.26 x 2800 = 3528 cm² so: 2 openings of 40 x 90 cm.
39