Location Of The Remote Controller; Description Of Remote Control - Olimpia splendid Unico twin Mode D'emploi Et D'entretien

• if the remote control is not used for several weeks or longer, remove the batteries.
Any leaks from the batteries could damage the remote control.
• the average life-span of the batteries, with normal use, is approx. six months. replace the batteries when
the indoor unit command receipt "beep" can no longer be heard, or if the transmission indicator on the
remote control does not switch on.
Do not re-charge or disassemble the batteries. Do not throw the batteries into the fire.
They can burn and explode.
If the battery liquid falls onto the skin or clothes, wash well with clean water. Do
not use the remote control with batteries that have leaked.
The chemical products contained in the batteries can cause burns or other risks
to health.
6.3.3 -

LOCATION OF THE REMOTE CONTROLLER

• Keep the remote control in a position from which the signal can reach the appliance receiver (maximum
distance is about 8 meters - with charged batteries) (fig. 38).
the presence of obstacles (furniture, curtains, walls, etc.) between the remote control and the appliance
reduces the remote control range.
6.3.4 -

DESCRIPTION OF REMOTE CONTROL

the remote control is the interface between the air-conditioner and the customer, so it is very important to
learn all its functions, the use of the various controls and the meaning of the symbols marked on it.
REMOTE CONTROL
B1 activation/deactivation (Stand-by) of the unit
B2 minimum, medium, maximum or automatic ventilation speed
selection
B3 activation/deactivation of the function SILENT
B4
activation/deactivation of the oscillation function of the air
outlet flap
B5 operating mode selection
- cooling > heating > ventilation >
> dehumidification > automatic
B6 Desired/clock/programming temperature increase
B7 Desired/clock/programming temperature decrease
B8
activation/deactivation of the report console display
B9 Clock/programming setting
B10 activation/deactivation of the functions
programming 1 / programming 2
B11 activation/deactivation of the display on board of the machine
switching on
B12 Desired temperature unit selection °C/f
EN - 36
B1
B2
B3
B4
B9
B10
B8
B5
B6
B7
B12
B11
G