C - Location Of The Remote Control; Use Of The Appliance; A- Preliminary Operations; B- Appliance Switching On/Off - Olimpia splendid UNICO EASY S1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 59
If the battery liquid falls onto the skin or clothes, wash well with clean water. Do
not use the remote control with batteries that have leaked.
The chemical products contained in the batteries can cause burns or other risks
to health.

3.3.c - Location of the remote control

• Keep the remote control in a position from which the signal can reach the receiver (24) of the appliance
(maximum distance is approx. 8 metres - with charged batteries) (figure 24).
the presence of obstacles (furniture, curtains, walls, etc.) between the remote control and the appliance
reduces the remote control range.

3.4 USE OF THE APPLIANCE

Work as follows in order to use the appliance.
To prevent possible damages to the compressor, each start is delayed by 3 minutes
with respect to the last switching off.
3.4.a Preliminary operations
• Place the appliance on a stable and not inclined base, at at least 30 cm. from
the wall or from any other object, in order to ensure the correct air circulation.
Place it on a water-resistant surface since the possible water leakage could
damage furniture or the floor.
• Do not place the appliance directly on carpets, towels, blankets or other absor-
bent surfaces.
• Insert the plug in the power socket; the appliance emits a "beep", on the display
appears the icon
Before electrically connecting the appliance, make sure the plate data correspond
to those of the electricity distribution network.
3.4.b Appliance switching on/off
a. to start the appliance, press the key "ON/OFF" on the remote control or the key
b. a beep signals that the appliance is operating.
c. the icon
switches on on the control panel.
d. appears on its display
e. in case of prolonged stop of the appliance, it must be reset by removing the plug from the power socket,
wait 5÷10 seconds and then reinsert it; a beep signals that the appliance is ready for use.
and the environment temperature in °C.
appears on its display.
on the control panel.
EN - 17
UNICO EASY S1

Publicité

Table des Matières
loading

Table des Matières