Publicité
Les langues disponibles
Les langues disponibles
3.3.c - Location of the remote control
• Keep the remote control in a position from which
the signal can reach the receiver (29) of the appli-
ance (maximum distance is approx. 5 metres - with
charged batteries) (figure D).
The presence of obstacles (furniture, curtains, walls,
etc.) between the remote control and the appliance
reduces the remote control range.
3.4 - USE OF THE APPLIANCE
Work as follows in order to use the appliance.
To prevent possible damages to the compressor, each start is delayed by 3 minutes
with respect to the last switching off.
3.4.a - Preliminary operations
•
Place the appliance on a stable and not inclined base, at at least 50 cm. from
the wall or from any other object, in order to ensure the correct air circulation.
Place it on a water-resistant surface since the possible water leakage could
damage furniture or the floor.
•
Do not place the appliance directly on carpets, towels, blankets or other absor-
bent surfaces.
•
Insert the plug in the power socket; the appliance emits a "beep" and all the
LEDs switch on for a few seconds, the appliance switches to stand-by mode.
Before electrically connecting the appliance, make sure the plate data correspond
to those of the electricity distribution network.
3.4.b - Appliance switching on/off
a. The appliance can be switched ON or OFF for short periods by pressing B1 on the remote control or
SW1 on the control panel (if the appliance is switched off for a long period then it should be deactivated
by removing the plug from the mains supply.
b. In case of prolonged stop of the appliance, it must be reset by removing the plug from the power socket,
wait 5÷10 seconds and then reinsert it; a beep signals that the appliance is ready for use.
To set the automatic switching on/off of the appliance, please refer to the paragraph "Timer Mode".
29
~5m
DOLCECLIMA BREZZA
D
EN - 21
Publicité
Chapitres
