General Data; Safety Informations; Safety Check List - Mouvex MH6 Notice D'instructions

1.

GENERAL DATA

REMARKS
MOUVEX truck screw-type compressors MUST be installed in
systems designed by qualified personnel. The installation MUST
be in compliance with local standards, national regulations and
rules of safety.
This manual is designed to permit installation and
commissioning of MOUVEX truck screw-type compressors
and MUST accompany the compressor.
Maintenance of MOUVEX
must ONLY be carried out by qualified technicians. This
maintenance must meet local and national standards as
well as all safety regulations.
Read this manual, including all instructions and warnings,
in full BEFORE any use of MOUVEX compressors.
Do not remove the warning and use label stickers that are
found on the compressors.
1.1.

Safety informations

This is a SAFETY ALERT SYMBOL.
When you see this symbol on the product, or in the manual, look
for one of the following signal words and be alert to the potential
for personal injury, death or major property damage.
Warns of hazards that WILL cause serious personal injury,
death or major property damage.
Warns of hazards that CAN cause serious personal injury, death
or major property damage.
Warns of hazards that CAN cause personal injury or property
damage.
6
General data
screw-type compressors
NOTICE
Indicates special instructions which are very important and
must be followed.
1.2.

Safety check list

1. Before operating the compressor, ensure the vessel to
which the compressor is connected is certified to withstand
the pressure and/or vacuum produced.
2. Verify adequately sized relief valves have been fitted to
protect the vessel. Do not use solvents or inflammable
products for cleaning the pipelines and the accessories.
3. Gas/air mixtures which are potentially volatile/explosive
must not be introduced or allowed to be introduced into the
compressor.
4. All pressure vessel and piping connected to the compressor
must be isolated and in a safe operating condition.
5. Operators should wear ear protection when operating truck
mounted compressors.
6. There are components within the compressor of sufficient
weight to cause injury if mishandled. Use proper lifting
devices as necessary.
7. Where necessary, this equipment should be grounded to
control static electricity.
8. The temperature of the air leaving the compressor is
elevated above ambient due to air compression. Check
that the elevated temperatures do not adversely affect the
product and any material used in design of the system.
Attach clearly marked warning signs to warn of potentially
hot surfaces on the compressor, piping and accessories
which will burn if touched.
9. Mounting of the compressor must be correctly engineered
and the compressor must be properly secured. Refer to the
chapter 4. INSTALLATION OF THE COMPRESSOR UNIT.
NOTICE
MOUVEX COMPRESSORS ARE NOT DESIGNED FOR
HANDLING LIQUID, POWDER OR CONDENSATE.
TO DO SO WILL VOID THE WARRANTY.