SOMFY Sunea 40 RTS DC Notice Originale page 18

2. 3. 4. Programming/adding a RTS sensor
Open the memory of the motor from the individual
1)
control transmitter:
Press the "Prog." button of the transmitter for about 3
-
seconds until the motor jogs in both directions.
&RQ¿UP WKH RSHUDWLRQ IURP WKH VHQVRU \RX ZLVK WR DGG
2)
Press the "Prog." button of the sensor for less than 1
-
second. The motor will jog in both directions.
The operation is completed.
1
Recommendations when using a RTS Sensor:
If the RTS sensor on an installation is changed or
deleted, it is important to delete it from the memory of
all the motors in which it was programmed: perform
operations 1 with a programmed transmitter, then
perform the operation 2 with the sensor to be deleted.
2. 3. 5. « Back impulse » fonction
This function enables the release of the fabric tension after an opening order. This function
will only be activated once the installation of the motor is completed. To activate the function
and set the release angle between 11& 180°, the procedure is:
1- Move the motor to the down end limit with the
1)
"Down" button.
2- Press simultaneously for 5 seconds the "Up" and
2)
"My" buttons, The motor jogs in both directions.
3- Adjust the angle of back impulse function (between
3)
11 and 180°) with the "Up" and "Down" buttons.
 &RQ¿UP WKH VHWWLQJ E\ SUHVVLQJ  VHFRQGV WKH "My"
4)
button. The motor jogs in both directions.
The operation is completed.
To disable the Back impulse, set the angle to 0°.
The "back impulse" function is disabled in factory
mode.
2. 3. 6. « Back release » function
This function enables the release of the fabric tension after the complete closing of the box
awning. For safety reasons, this function can only be activated or deactivated by the
individual control point in 3 situations:
‡ $IWHU WKH VHWWLQJV FRQ¿UPDWLRQ DQG EHIRUH SURJUDPPLQJ WKH ¿UVW FRQWURO SRLQW
‡ $IWHU SURJUDPPLQJ WKH ¿UVW FRQWURO SRLQW DQG GXULQJ WKH QH[W  F\FOHV
‡ $IWHU D VLQJOH SRZHU RXWDJH DQG GXULQJ WKH QH[W  F\FOHV
To activate or deactivate this function, the procedure is :
Retract the awning using the «UP» button.
1)
Press simultaneously the "My" and "Down" buttons
2)
for 5 seconds, the motor jogs. The operation is
completed.
The "back release" function is disabled in factory
mode.
6 Images are not contractually binding.
Adding
1)
PROG.
a
Deletion
c
1)
PROG.
a
1)
3)
1)
0.5 s
Copyright © 2014 Somfy SAS. All rights reserved.
c
2)
PROG.
c
c
2)
PROG.
c
2)
5 s
4)
2 s
2)
5 s