Installation; Assembly; Tube Preparation - SOMFY Sunea 40 RTS DC Notice Originale

Safety warning!

2. INSTALLATION

1
Instructions which must be followed by the drive and home automation professional
installing the drive.
1
Never drop, knock, drill or submerge the drive.
1
Install a separate control point for each drive.

2. 1. ASSEMBLY

1
&KHFN WKH VWUHQJWK RI WKH UROOHU VKXWWHU DQG LWV ¿WWLQJV
1
Keep a minimum distance of 8 in. (0,2m) between 2 Sunea 40 RTS DC motors.
1
Keep a minimum distance of 12 in. (0,3 m) between Sunea 40 RTS DC motors and RTS
transmitters.
1
A radio appliance using the same frequency (433,42 MHz) may reduce our product's
performance (ex.: wireless headphones).
1
Use valence with an antistatic fabric.
2. 1. 1. Preparing the drive
1
Check that the inner diameter of the tube is 37 mm or
greater.
Fit the accessories required to integrate the drive in
1)
the roller tube :
‡ (LWKHU ¿W WKH GULYH ZKHHO a) on the drive.
‡ 2U ¿W WKH FURZQ b) and the drive wheel (c) on the drive.
Measure the length (L1) between the inner edge of the
2)
drive head and the rim of the drive wheel.

2. 1. 2. Tube preparation

Cut the roller tube to the required length, depending on
1)
the motorised product.
Deburr the roller tube and remove the swarf..
2)
For roller tubes which are smooth inside, cut a notch
3)
with the following measurements:
Ø 40 x 1.5 mm
Ø 40 x 1 mm
2. 1. 3. Drive/tube assembly
Slide the drive into the roller tube.
1)
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
Secure the roller tube onto the drive wheel using 3
2)
self-tapping screws or 3 steel pop rivets positioned
between 5 mm and 15 mm from the outer edge of the
drive wheel, for all types of roller tube.
1
The screws or pop rivets must only be attached to the
drive wheel and not to the drive.
2
d e
7 mm 8.5 mm
6 mm 8.5 mm
Images are not contractually binding.
1
Caution!
1)
Ø = 37 mm
2)
1)
3)
1)
2)
Copyright © 2014 Somfy SAS. All rights reserved.
Information
Ø > 37 mm
a b c
L1 = ...
L1
2)
d
e
L1