Commissionning - SOMFY Sunea 40 RTS DC Notice Originale

2. 3. COMMISSIONNING

2. 3. 1. End-limit setting:
1
Only one motor should be powered at a time
2. 3. 1. 1. Connect the motor to the 12V power supply, and
press simultaneously on the "Up" and "Down" buttons
of a Somfy RTS transmitter. The motor will jog (turns 0.5
second in one direction and then in the other).
This transmitter now controls the motor in unstable
mode. Go to section 2.3.1.2.
2. 3. 1. 2. Test and change the rotation direction
Press on the "Up" button on the transmitter:
If the tube turns in the up direction, go to section
a)
2.3.1.3, or 2.3.1.4.
If the tube runs in the down direction, reverse the
b)
rotation direction by pressing the "My" button for
DW OHDVW  VHF XQWLO WKH PRWRU MRJV &RQ¿UP WKDW WKH
new rotation direction is now correct. Go to section
2.3.1.3 or 2.3.1.4.
2. 3. 1. 3. Semi-automatic setting for awnings with blockers for up end limit
Move the motor to the desired down end limit position
1)
using the "Up" and "Down" buttons. If you hold the
"Up" or "Down" button for more than 2 seconds the
awning will move automatically in the up or down
direction. You will then have to stop the awning at
the desired end-limit position by pressing the "My"
button.
To set the down end limit position, press
2)
simultaneously the "My" and "Up" buttons. The
motor will run automatically in the up direction.
Press "My" to stop the motor.
3)
7R FRQ¿UP WKH HQG OLPLWV SUHVV IRU  VHFRQGV RQ
4)
"My" until the motor jogs. The operation is completed. Go to section 2.3.2.
If you do not want to use this transmitter as the individual control, switch the power supply
off (2 seconds minimum).
4 Images are not contractually binding.
ON
12V
a
b
1)
3)
Copyright © 2014 Somfy SAS. All rights reserved.
2.3.1.2
OK
OK
2 s
2)
4)