Installing the Cover
Catch
Installing the
Dust Protection Ring
Disassembling
the Mounting Unit
Dropping the Lower Ram
Removing the
Dust Protection Ring
Removing the Cover
6
LaboPress-3
Instruction Manual
Unscrew the fixation screw about 10 mm.
Place the mounting cylinder over the lower ram with the
fixation screw in the position shown.
Turn the mounting unit in a clockwise direction until it stops.
Tighten the fixation screw completely.
Mount the tube with the straight quick coupling on the lower
quick coupling (position 4) of the mounting unit and push to
connect. Make sure that the ring comes to stop in the extreme
end of the quick coupling.
Mount the tube with the elbow quick coupling on the upper
quick coupling of the mounting unit (pos. 3) and push to
connect. Make sure that the ring comes to stop in the extreme
end of the quick coupling.
Mount the plug (pos. 5) in the socket. Tighten the coupling
nut.
Insert the barb into the front of the opening for the cover.
Insert the barbs on both sides of the cover into the cabinet.
Press the sides of the cabinet gently.
Press the rear end of the cover in so that the catch engages.
Place the dust protection ring around the mounting cylinder. The
concave side should face upwards.
Switch on the main power of the machine.
Press the key RAM DOWN
limit.
Lift out the dust protection ring.
Press the catch (position 4 above).
Press gently on both sides of the cover, to release it, and lift it
up.
N
to lower the ram to its lower