Struers LaboPress-3 Mode D'emploi page 5

LaboPress-3
Instruction Manual
LaboPress-3
Safety Precaution Sheet
To be read carefully
before use
1. The operator should be fully aware of the use of the machine according
to the Instruction Manual.
2. The machine must be placed in a well ventilated room on a working
table with adequate height for convenient operation.
3. Be sure that the actual voltage corresponds to the voltage stated on the
back of the machine and on the heating/cooling unit. The machine must
be earthed.
4. Be sure that the water connections are mounted correctly and without
leaks. The main water supply should be turned on when the machine is
in use.
Struers recommend that the mains water supply is shut off or
disconnected if the machine is to be left unattended
5. Be sure that the outlet hose is safely attached to the water outlet
system.
6. Be sure that the mounting unit is correctly assembled on the press
before starting the process.
7. Be sure that the top closure with upper ram is either correctly mounted
on the mounting cylinder or completely removed from the mounting
cylinder before starting the press.
8. Do not operate the mounting press with a higher force/pressure than
recommended for the actual cylinder diameter and resin in Struers
Application Guide for Hot Mounting.
9. Following a heating cycle, ensure the mounting cylinder is cooled for a
minimum of two minutes before opening.
10. Do not operate the machine whilst assembling or disassembling the
mounting unit.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).