Starting/Stopping The Cutting Process - Struers Unitom-2 Manuel D'instructions

Starting/Stopping
the Cutting Process
10
Unitom-2
Instruction Manual
 Carefully close the protection guard.
 Press the button START
wheel starts rotating and the cooling water is turned on.
 Carefully lower the cut-off wheel by drawing the cutting handle
downwards until the cut-off wheel touches the workpiece.
 Let the cut-off wheel work itself a little into the workpiece. Then
increase the force and begin the cutting.
 When the cut-off wheel has almost cut through the workpiece
the cutting force should be reduced.
 When the cut-off wheel has cut through the workpiece the
cutting handle is returned to its top position.
 Press the button STOP
water.
 Open the protection guard and release the workpiece from the
quick-clamping device.
Unitom-2 is equipped with a protection guard and a guard lock. The lock
prevents access to the cutting chamber when the cut-off wheel is running.

After pressing STOP
5 seconds. This safety function ensures that the cut-off wheel has stopped
before you access the cutting chamber.

to start the machine. The cut-off

to stop the cut-off wheel and cooling
IMPORTANT
the protection guard cannot be opened for about