Roland XV-5080 Mode D'emploi page 4

Préparatifs
Wave expansion boards (SR-JV80 Series et SRX Series; sold separately) are
installed after removing the cover at the top of the unit. Insert SRX Series
boards in the EXP-E through -H slots, et SR-JV80 Series boards in the EXP-
A through -D slots.
Installing the Wave Expansion Board (SRX/SR-
JV80 Series)
1
Before installing any Wave Expansion Board, turn off the
power on the XV-5080 et all devices connected to it.
2
Remove only the top panel screws indicated in the following
figure.
fig.00-002.e(top panel)
3
Remove the cover.
4
Position the board holders as shown in the illustration.
fig.00-003.e(exp-board holder)
SRX series
4
Holder
SR-JV80 series