Replacing A Spoke - CAMPAGNOLO PISTA Manuel D'instructions Et D'entretien

• Before proceeding with assembly, check in the technical specifications on page 4 the type and length of the spoke to be replaced, the recommended
value and the maximum value which must not be exceeded when tightening the spokes.
• Check that there are no residues of sand or any other foreign material inside the rim and, if necessary, remove them with a jet of compressed
air.
• Obtain an original Campagnolo
• Always prevent the rotation of the spokes when nuts are tightened or loosened. Make sure that no damage is caused to the surface of the spokes.
CAUTION!
Take special care when handling the spokes during assembly to prevent accidentally scrat-
ching the rim.
Note
If you have to replace a rear wheel spoke on the track sprocket side, the latter must be removed prior
to any work (see Section 5).
• Using a 5 mm hex wrench, completely unscrew the nut of the spoke to be replaced (Fig. 20), holding
the latter steady to prevent rotation.
WARNING!
Be very careful not to damage the spokes. Using wheels that have not been centred properly
or which have broken or damaged spokes may result in accidents, personal injury or death.
14

8. REPLACING A SPOKE

® replacement spoke.
20
5 mm