Log Placement - Napoleon HD35NT-2 Manuel D'installation Et D'utilisation

finishing
EN
10.7

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
The individual logs can be easily identified by the numbers cast on the underside of each log. Phazer
glowing embers exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect that is different in every
installation. Take the time to carefully position the glowing embers for a maximum glowing effect. During the initial
use of the appliance, log colours may vary. During the initial use of the appliance the colours will become more
uniform as colour pigments burn in during the heat activated curing process.
A. Place the rear log (W135-0339) on rear bracket, ensure the log is
seated properly on the rear bracket and located on the center pin.
B. Place the hole in part B of the middle log (W135-0409) onto the pin
on the left side of the burner pan. Then, place the hole in part A of
the middle log (W135-0409) onto the pin on the right side of the
burner pan.
HD35-2 / HD40-2: Place the log charcoal strip (W135-0408) on top
C.
of the front grate by engaging the two cut out notches onto the two
middle posts of the front grate.
HD46-2: Place the log charcoal strip (W135-0408) on top of the
support ember strip.
46
W415-2197 / C / 10.14.20
LOG IDENTIFICATION CHART
LOGS HD35-2
Rear Log
Middle Log
Left Log
Right Log
Charcoal Strip Log
Base Left Log
Base Right Log
HD40-2 HD46-2
W135-0339
W135-0409 (part A & B)
W135-0406
W135-0407
W135-0408
N/A W135-0392
N/A W135-0393
logs and
TM
48.1
B
A