Glowing Ember Placement; Logo Placement - Napoleon HD35NT-2 Manuel D'installation Et D'utilisation

finishing
EN
10.8

glowing ember placement

WARNING
!
• Completely blocking the burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed
ignition.
Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should be
taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow.
The ember material will only glow when exposed to direct fl ame; however, care should be taken to not
block off the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZER™ logs available from
your local authorized dealer / distributor.
10.9

logo placement

Remove the backing of the logo supplied and place on the glass viewing door or bottom access panel as
illustrated.
48
W415-2197 / C / 10.14.20
1/2" 13mm
LOGO
1/2" 13mm
22.1A