Optional Blower Installation; Accessing The Blower; Installing The Blower - Napoleon HD35NT-2 Manuel D'installation Et D'utilisation

WARNING
!
• Risk of fire and electrical shock.
• Turn off the gas and electrical power before servicing this appliance.
• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. using non-
listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could result
in a safety hazard and will void the warranty and certification.
• Ensure that the fan's power cord is not in contact with any surface of the appliance to prevent electrical
chock or fire damage. Do not run the power cord beneath the appliance.
• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excess
wire is contained, preventing it from making contact with moving or hot objects.
7.1

accessing the blower

WARNING
!
• Be careful not to tear the burner train gasket. A replacement gasket can be ordered from your local
authorized dealer / distributor.
note:
If optional brick panels have been installed, they will need to be removed prior to proceeding.
Remove the control access panel.
A.
Remove the door (see "glass door
B.
removal / installation" section).
Carefully remove the log set and
C.
optional brick panels if installed
(see "log placement" section).
Remove the 2 screws holding the
D.
front grate in place.
Remove the 2 screws holding the
E.
rear log support.
Remove the 9 perimeter screws
F.
as illustrated and lift out the burner
base assembly and gasket. The
gas line flex-connector should
provide sufficient movement to permit shifting the burner assembly on its side.
7.2

installing the blower

Open the blower kit and
A.
remove the thermal disc from
the bracket. Remove the speed
control bracket from the burner
base assembly, install the
thermal disc and speed control
switch onto the speed control
bracket and reattach to the
burner base.
Reverse procedure to re-
B.
assemble.

7.0 optional blower installation

FRONT
REAR LOG
GRATE
SUPPORT
CONTROL ACCESS PANEL
FRONT
GRATE REAR LOG
PERIMETER SCREWS
SUPPORT
CONTROL ACCESS PANEL
PERIMETER SCREWS
SPEED CONTROL
BRACKET
BLOWER
GASKET
SPEED CONTROL
BRACKET
BLOWER
GASKET
FRONT
REAR LOG
GRATE
SUPPORT
CONTROL ACCESS PANEL
PERIMETER SCREWS
SPEED CONTROL
BRACKET
THERMAL
DISC
BLOWER
GASKET
SPEED
CONTROL
SWITCH
W415-2197 / C / 10.14.20
EN
VARIABLE
SPEED
KNOB
35