Electrical Information - Napoleon HD35NT-2 Manuel D'installation Et D'utilisation

6.0 electrical information

EN
WARNING
!
• Do not use this appliance is any part has been under water. Call a qualified service technician immediately
to have the appliance inspected for damage to the electrical circuit.
• Risk of electrical shock or explosion. Do not wire 110V to the valve or to the appliance wall switch.
Incorrect wiring will damage controls.
• All wiring should be done by a qualified electrician and shall be in compliance with local cides. In the
absence of local codes, use the current CSA22.1 Canadian Electrical Code in Canada or the current
National Electrical Code ANSI/NFPA No. 70 in the United States.
• Always light the pilot whether for the first time or if the gas supply has run out, with the glass door opened
or removed.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence of
local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the ANSI/NFPA 70-1996
NATIONAL ELECTRICAL CODE in the United States.
It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence of
local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA 70-1996 national
electrical code in the United States.
32
W415-2197 / C / 10.14.20