Table des Matières
Publicité
2 S I N G L E S H O T
switching between the different modes of the single shot unit can also be done per lever on the fork crown.
therefore, some of the pieces have to be exchanged on the top of the cartridge.
2.1 REQUIRED MATERIAL
• t8 torx screwdriver
• 2mm hex key
• 2,5mm hex key
• 8mm nut
• loctite 241 (bolt lock)
2.2 DISASSEMBLING THE REMOTE CONTROLS
• loose the M4x4 screw on the remote wheel to remove the cable
• remove the remote lever from the handlebar using a 2,5mm hex key. also remove the cable and housing
• loose the torx screw on the top of the red rebound damping wheel with the t8 torx screwdriver. secure the red wheel with
your fingers during this operation
• remove the red wheel
• loose the M5 screw nut with the 8mm nut
• remove the remote wheel
• remove the steel insert. caution: by pulling the insert up, the spring will return quickly to its position and turn the hex
wheel promptly on about 360°
• remove the spring
2.3 ASSEMBLING THE STANDARD CONTROLS
• place the lever on the regulation pin and orient it in position 1
• Mount the M5 nut and tighten it
INFORMATION
control the function of your fork
• the lever should be able to turn freely on 70° with two well defined positions
• in position 1, the fork should be open
• in position 2, the fork should be closed in the top position
• put the red rebound damping wheel back on the hex of the regulation pin
• put some loctite 241 on the thread of the torx screw
• push on the red wheel and make sure all the surfaces are fitting together
• tighten the torx screw with the t8 torx screwdriver
Pos 1
Single Shot
Lockout open
MAN_forks_remote2standard_E-D-F_20101216.indd 5
Pos 2
Single Shot
Lockout closed
5
17.12.10 09:07
Publicité
Table des Matières
