Vacuum Supply; Electric Power Supply - Heidolph ROTAVAC valve control Mode D'emploi

E
Remove coupling nut (10) from
-
condensate cooler (Attention,
retainer underneath coupling nut!)
- Locate condensate cooler (2) in
holder
- Install receiving flask (4) and
secure with clamp (5).
- Fit red coupling ring (10) and seal
(9) on right-hand end of PTFE
hose (7). Plug this line assembly
in glass thread (18) of aftercooler
(2). Plug left-hand over outlet stud
(6), pull coupling nut tight.
- Connect cooling water with fittings
(11), exhaust air with fitting (14),
as required.
3.3.

Vacuum supply

- Vacuum supply is connected with inlet fitting (12)
3.4.

Electric power supply

- Before connecting power supply with mains network check whether:
actual voltage is identical with voltage depicted on data plate (refer to "Safety
Information"); Refer to "General" for more information of plug connectors used.
Caution: ROTAVAC vario tec consists of a pump (24V=) and a power supply module
(mains voltage)
- Connect power cord with wall outlet.
- Connect pump wire with control box (also refer to LABOROTA 4002/4003 Owner's Manual)
6
7
10
14
2
1
17
6
12
7
5
10
9
48
18
4
18
11