Connecting The Power Supply - Heidolph EKT Hei-Con Mode D'emploi

E
PIN configuration of the 5-pole plug
2.5

Connecting the power supply

Danger
Make sure that the switching function is functioning safely when using
the EKT Hei-Con with devices other than the magnetic stirrer (MR)
Hei-Tec, Hei-Tec [ ].
The instrument requires a direct voltage potential of 8-15 V.
Magnetic stirrers MR Hei-Standard, Hei-Tec, Hei-Tec [ ], MR 3001K, MR 3002 etc.
These units supply the EKT Hei-Con with current. You have thus already connected the
power supply as described under section "Electrical connection".
Connect the magnetic stirrer or heating unit to the power supply.
The EKT Hei-Con has no switch. It is switched ON and OFF using the ON/OFF switch for
the magnetic stirrer. When using a plug power supply unit, disconnect it from the mains.
22