Instructions For The Installer; Fitting The Feet; Electrical Connection - Hendi 225523 Mode D'emploi

The manufacturer and dealer is not liable for any
inaccuracies due to printing errors or transcrip-
tion, in this manual. In line with our policy of con-
tinuous improvement products, we reserve the

5. INSTRUCTIONS FOR THE INSTALLER

The following instructions are aimed at the quali-
fi ed installer, to ensure that he carries out the in-
stallation, adjustment and maintenance operations
as correctly as possible and according to current
legal regulations. Any operation must be per-
formed with electrical power cut to the appliance.

5.1 FITTING THE FEET

The feet are inside the appliance and must be secured on the four threaded holes on the base. If necessary,
the height of the feet can be adjusted by screwing or unscrewing.
5.2 POSITIONING
EN
Position the appliance perfectly horizontally on a ta-
ble or similar support (the table or support must
be at least 85 cm above the fl oor). Position it at a
distance of not less than 10 cm from the side and
rear walls, to enable natural ventilating air to cir-
culate freely around it. The appliance is ventilated
through specifi c openings on the metal walls of the
outer housing, and ensures effi ciency and long-life.
For this reason it is strictly forbidden to obstruct

5.3 ELECTRICAL CONNECTION

The appliance must be connected to the electri-
cal mains according to current legal regulations.
Before making the connection, make sure of the
following:
• the voltage and frequency values of the power
supply system match the values on the "technical
data" plate affi xed on the appliance;
• the limiting valve and the system are able to
support the appliance's load (see the "technical
data" plate);
6
right to make modification of the product, pack-
aging and specifications contained in the Docu-
mentation without prior notice.
Before using the appliance, carefully remove the
special adhesive fi lm protecting the parts in stain-
less steel. Do not leave any glue residues on the
surfaces. If necessary, remove them at once, with
an appropriate solvent.
these ventilation openings, even partially or for
short periods. Failure to observe this specifi c pro-
hibition releases the manufacturer of the appliance
from all responsibility and immediately voids any
guarantee rights for the said appliance, because its
constructive conformity has been voluntarily com-
promised. Furthermore, the appliance is not suita-
ble for embedding and for grouped positioning with
other identical appliances.
• the power supply system has an adequate earth
connection according to current legal regulations;
• a omnipolar switch with minimum between-con-
tacts aperture of the overvoltage category III
(4000 V), sized to the load and conforming to
current legal regulations, is fi tted between the
appliance and the mains in the direct connection
to the mains;
• the omnipolar switch used for connection is easy
to reach when the appliance is installed;