Struers Movipol-3 Mode D'emploi page 3

Movipol-3
Instruction Manual
Movipol-3
Safety Precaution Sheet
To be read carefully
before use
1. The operator must be fully instructed in the use of the apparatus,
according to the User's Guide.
2. The operator must be fully instructed in the use of the electrolytes used
with Movipol-3.
3. Observe the current safety precautions regarding the handling, mixing,
filling and disposal of the electrolyte (see section Safety Precautions).
The Material Safety Data Sheet for each of the Struers electrolytes can
be supplied upon request.
4. Be sure that the actual voltage corresponds to the voltage stated on the
type plate of the apparatus.
5. Check that the apparatus is standing firmly on the support. If the
apparatus is carried or hung by the shoulder strap, check that the strap
is intact and that the buckle is correctly fastened.
6. Always check that the pump motor is working before taking the pencil
out of its holder.
7. Always place the pencil in its holder when it is not used.
8. Do not leave the apparatus unattended when filled with electrolyte.
9. Make sure that the apparatus is safely secured during transportation
and that is does not contain electrolyte.
10. The maximum polishing voltage allowed at the work site must be
observed.
The equipment should only be used for its intended purpose and as detailed in the Instruction Manual.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for damage(s)
to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).