Maintenance And Troubleshooting; User Maintenance; Cleaning The Apparatus; Cleaning Laserprobes - Enraf Nonius Endolaser 422 Mode D'emploi

As previously mentioned, the Endolaser is an IR diode laser band generator, designed and produced
according to national and international safety standards (see Appendix) and is classified as CLASS III B
laser equipment. However, it must be remembered that caution is required when operating these
machines to reduce risks (considered as quite low given the power specifications related to IR diode
radiation) in association with a light source laser which is intrinsically monochromatic, directional,
coherent and brilliant.
CAUTION:
The laser radiation emitted by the machine is intrinsically dangerous: use the special protective goggles
at all times; do not look at the beam either with naked, unprotected eyes or with optical instruments; avoid
unprotected exposure to the beam; avoid exposure of the eyes to direct or diffused radiation.
Direct exposure for a fraction of a second to laser radiation certainly does not constitute problems
however, prolonged exposure creates harmful effects. Any damage is in direct relation to the power of the
emitter.

6 Maintenance and Troubleshooting

6.1

User maintenance

The Endolaser machine for laser therapy does not require any particular maintenance except for
cleaning.
WARNING:
•
Before carrying out any maintenance or cleaning procedures on the equipment, MAKE SURE TO
TURN OFF the unit by the switch on the rear panel and disconnect it from the mains.
•
In order to guarantee the operation of the machine in conditions of absolute safety for the patient,
it is advisable to subject the machine to a periodical check cycle (at least 2 years) to be
performed by an authorized Enraf Nonius technician.
•
For optimal use of the equipment and to guarantee its maximum performance, it is recommended
that the maintenance actions are carried out correctly and in the recommended times.
6.1.1

Cleaning the apparatus

When cleaning the outer part of the equipment, make sure to use a soft, clean cloth dampened with
lukewarm water and a non-abrasive liquid household cleaner. (No abrasive, no alcohol content solutions)
The front panel can be cleaned in the same way.
CAUTIONS:
•
The cleaning and relative disinfection (probe and equipment) must be carried out in a systematic
way before the execution of the therapeutic treatment to be submitted to the patient.
•
When cleaning the outer part of the equipment, do not use detergents, acid solutions, abrasive or
aggressive solutions or inflammable substances.
•
Use of any of the above mentioned substances or improper use of the accessories will cause
irreparable damage to the equipment and the guarantee will be no longer valid. Do not spray or
pour liquid on the external parts of the equipment, or into the air holes on the casing.
•
Do not immerse the unit into water.
•
After cleaning the exterior part of the equipment, make sure to dry it perfectly before turning on
the unit.
•
The unit must under no circumstances be opened or dismantled in order to clean or check inner
parts – Endolaser equipment does not require cleaning of inner parts and in all cases, only
specialized technicians of Enraf-Nonius BV. should carry out such operations.
•
Check the integrity of the cord set and the cables connecting the Laserprobe at frequent intervals:
these should never present damage or wear and tear
6.1.2

Cleaning laserprobes

To prevent corrosion, clean and dry the contact surface immediately after use. Make sure that nothing
remains on the laserprobes surface. We further recommend cleaning the applicator and cable daily, using
lukewarm water. The laserprobe surface can be disinfected using a cloth moistened with a 70% alcohol
solution. Check the laserprobe and cable regularly for damage.
EN
6.1.3

Cleaning safety glasses

16
Please refer to the "maintenance and cleaning instruction manual" included with the safety glasses.