Safety Instructions Relating Specifically To The Equipment - Meister TBS350-2M Traduction Du Manuel D'utilisation Original

5452530-Tischbohrm_man 09.03.18 07:23 Seite 44
• Damaged switches must be replaced
by a customer service workshop.
CAUTION! The use of other tool
inserts and other accessories
may pose a risk of injury.
• Safely store unused electrical tools.
Unused electrical tools should be
stored in a dry place that is high up
or locked, out of reach of children.
• Wear a hair net if you have long
hair.
• Protect the power cable from heat,
oil and sharp edges.
• Pull the plug out of the socket
when the tool is not in use, before
maintenance and when changing
tools, for example, saw blade, drill,
mill.
6 – Safety instructions
relating specifically to
the equipment
• Never hold workpieces with your
hands. Always use clamps or a
machine vice.
• Always use the correct drilling speed
to work.
• Before use always check that the
chuck, the worktable and the mounting
screws are properly tightened. Check
that the safety switch under the
transmission cover (10) is working
properly: the machine must switch off
when the cover is opened.
• Before cleaning, setting and adjusting
the drill or changing drill tools switch
off the drill and pull out the plug.
44
• Always work with the chip guard (7) in
place and wear protective goggles.
• Follow safety instructions for using
electrical equipment and the relevant
safety regulations.
• Never remove chips by hand.
• The workplace should be well lit.
• Do not wear gloves when working
with the device. There is a risk that
they will get caught!
Position of the user:
• Stand in front of the electrical tool.
This way you always have a good
view of the drilling site.
- Keep hands and fingers away from
the rotating insertion tool.
- Do not cross your arms in front of
the drive unit
• Turn the electrical tool off
immediately if the insertion tool is
blocked. The insertion tool is blocked
when:
- the electrical tool is overloaded or
- it is jammed by the work piece
being processed.
• Do not touch the insertion tool
after operating, before it has
cooled down. The insertion tool gets
very hot during operation.
• Never leave the tool before it has
come to a complete stop. Insertion
tools that are shutting down can
cause injuries.
Safety symbols
The symbols on the housing have the
following meanings: