Pictograms; Operation; Verification Before Use; Functions And Description - Tractel Davitrac+ Manuel D'installation, D'emploi Et D'entretien

2.2. Pictograms

Code
Symbol word Meaning
DANGER Hazardous
situation which, if
not avoided, will
result in death or
serious injury.
WARNING IMMEDIATE
or possi bly
imminent danger:
CAUTION Possibly
dangerous
situation:
Other NOTE Possibly
Advice dangerous
situation:
Instruction Documentation
for (None) in writing (i.e.
record keeping)

3. Operation

3.1. Verification before use

NOTICE
Before any installation work, the installer must have
this manual ready to hand.
Before inserting Davitrac™+ in a Tractel
• The product marking must be present and legible.
• Before each use, make sure that the product is in
a visibly good condition, free from marks, impacts
or deformation. If not, do not use it and inform the
supervisor.
• Make sure that the Davitrac™+ base is a Tractel
Davitrac base and that it is in good condition and
adequately secured to the structure if it is permanent.
It must be cleaned thoroughly on the inside and must
not be deformed.
• Make sure that the Davitrac™+ rotation ring fitted at
the bottom of the mast is in good condition before
inserting it into a Davitrac base.
• Make sure that all the rods are present, and that they
are not deformed or corroded. All rods must be locked
by locking pins.
• Before starting work, the installer must organise
the job so that installation work is carried out under
the required safety conditions, and particularly in
accordance with labour regulations. They must use
the collective and/or personal protective equipment
required for that purpose.
After inserting Davitrac™+ in a Tractel
• Check that the mast rotates freely in the base before
Possible
locking it in place using a rod with a locking pin.
consequence
• Check the condition of associated equipment.
of non-
• Check all the equipment brackets fastened to
compliance
Davitrac™+: They must not be deformed, cracked or
Will result
corroded.
in a Fatal
• Make sure that the Davitrac™+ mast is locked in its
or serious
base by means of the rod with a locking pin.
injuries!
If in doubt, do not use the product and inform the
supervisor.
Could result in
Fatal or serious
injuries!
Minor injuries
to persons!
Mounted floor and flush floor bases may only be
installed on horizontal surfaces. Wall mounted and
Damage to
clearance mural bases may only be installed on
equipment or its
vertical surfaces. Refer to the Tractel
surroundings
Davitrac™+ and davimast permanent bases" manual.
For all other applications, please contact Tractel
(None)
When using the temporary self-stabilising base,
you will need to adjust the level. Use the screw
mechanisms to compensate for an uneven and/or
sloping support surface. The self-stabilising base may
only be used if the ground is in good condition, stable
and non-slipping such as concrete, bitumen, etc. fig. 7.
Davitrac base:
®

4.1. Authorised uses and applications

1. Rope access solution with the Blocfor R as fall arrest
device and a Scafor or a Work winch as working rope.
2. Fall arrest and rescue solution with the Blocfor R.
3. Rescue solution with the Blocfor R in the event of
®
a fall.
4. Rescue solution with the Scafor or Work winch after
a fall to rescue the injured person.
5. Material lifting using the Scafor or Work winch fixed
with their respective bracket on the mast of the
Davitrac™+ with a maximum safe working load of
1100lbs (500kg). 2 persons can be secured on the
Davitrac™+ while lifting material.
6. Material lifting using a Minifor, a Tralift or any hoist
fixed on the material lifting anchor point on the head
of the Davitrac™+ with a maximum safe working
load of 1100lbs (500kg). 2 persons can be secured
on the Davitrac™+ while lifting material.
7. Prohibited use of any combination of material lifting
and rope access
WARNING
WARNING

4. Functions and description

Davitrac base:
®
EN
"Davitrac,
®
.
®
19