Motor Cooling; Storing The Machine - Stihl MSE 250 C Notice D'emploi

Picco 3/8" P 5.0 mm
Rapid 3/8"; 0.325" 6.0 mm
Rapid 0.404" 7.0 mm
If the groove is not at least this deep:
Replace guide bar
N
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
MSE 250 C

Motor Cooling

Use a dry brush or similar tool to
N
clean the cooling slots at regular
intervals – see "Maintenance
Chart".

Storing the Machine

For periods of 3 months or longer
Disconnect the plug from the wall
N
outlet.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
Thoroughly clean the machine,
N
especially the cooling air inlets.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
English
27