Taking Care Of The Guide Bar; Motor Cooling - Stihl MSA 200 C Notice D'emploi

Taking Care of the Guide Bar

2
1
Flip the bar – after each sharpening
N
and each time the chain is changed
– to avoid uneven wear, especially
at the sprocket nose and on the
bottom
Periodically clean the oil inlet
N
hole (1), oil outlet channel (2) and
bar groove (3)
Measure groove depth – using the
N
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
Chain type Chain pitch Minimum
groove depth
Picco 1/4" P 4.0 mm
If the groove is not at least this deep:
Replace guide bar
N
MSA 200 C
All manuals and user guides at all-guides.com
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
3
3

Motor Cooling

Periodically clean the ventilation
N
slots with a dry brush or the like
English
77