Stihl MSE 250 C Notice D'emploi page 6

English
Accessories
Only use those tools, guide bars, chains,
chain sprockets, accessories or
technically equivalent components that
have been approved by STIHL for this
machine. If you have any questions in
this respect, consult a servicing dealer.
Use only high quality tools and
accessories. Otherwise, there may be a
risk of accidents and damage to the
machine.
STIHL recommends the use of genuine
STIHL tools, guide bars, chains, chain
sprockets and accessories. They are
specifically designed to match your
model and meet your performance
requirements.
Drive Gear
Electrical Connection.
The wall outlet must be equipped with a
ground-fault circuit breaker or such a
device must be installed between the
wall outlet and the power tool – see
"Connecting Saw to Power Supply".
If the connecting cord is
damaged, immediately
disconnect the plug from
the power supply to avoid
the risk of electric shock.
4
Reduce the risk of electric shock:
Voltage and frequency of the
–
machine (see rating plate) and the
voltage and frequency of your
power supply must be the same.
Check the connecting cord, plug,
–
extension cord and safety devices
for damage. Never use damaged
cords, couplings and plugs or
connecting cords that do not comply
with regulations.
Always connect the power tool to a
–
properly installed wall outlet.
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition.
Never jerk the connecting cord to
–
disconnect it from the wall outlet. To
unplug, grasp the plug, not the cord.
Position the connecting and extension
cords correctly:
Check minimum cross section of
–
wires (wire gauge) – see
"Connecting to Power Supply".
To reduce the risk of stumbling,
–
position and mark the connecting
cord so that it cannot be damaged
or endanger others.
Using unsuitable extension cords
–
can be dangerous. Make sure the
extension cord used complies with
the regulations for the intended
application.
The plug and coupling of the
–
extension cord must be water-proof
and must never be immersed in
water.
Do not chafe on edges, pointed or
–
sharp objects
Do not squeeze through gaps in
–
doors or windows
If cords are twisted – unplug the
–
power tool and straighten them out
Always unwind the extension cord
–
completely from the cable drum to
reduce the risk of fire from
overheating.
The extension cord must always be
–
behind you (i.e. the operator).
Make sure that it cannot become
–
entangled with branches during
cutting.
Position the connecting cord so that
–
it cannot come into contact with the
rotating chain.
Do not drive over, squash or jerk the
connecting cord. Protect it from heat, oil
and sharp edges.
Before Starting Work
Disconnect the plug from the wall outlet:
before carrying out tests and
–
adjustments or cleaning work
when working on the cutting
–
attachment
before leaving your chainsaw
–
unattended
before transporting
–
before storing
–
before performing repairs and
–
maintenance work
in the event of danger or in an
–
emergency
MSE 250 C