Stihl MSE 250 C Notice D'emploi page 23

Filling Up with Chain Oil
N
Closing the Tank Cap
Grip must be vertical:
Fit the cap – marks on tank cap and
N
oil tank must line up.
Press the cap down as far as stop.
N
While holding the cap depressed,
N
turn it clockwise until it engages in
position.
The marks on the cap and oil tank are
then in alignment.
MSE 250 C
Fold the grip down.
N
Tank cap is locked.
If the tank cap cannot be locked in the oil
tank opening
Bottom of cap is twisted in relation to
top.
Remove the cap from the oil tank
N
and check it from above.
1
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi -
tion – inner mark is under the
grip. It is not in line with the
outer mark.
Place the cap on the opening and
N
rotate it counterclockwise until it
engages the filler neck.
Continue rotating the cap
N
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
Turn the cap clockwise and lock it in
N
position – see section on "Closing
the Tank Cap".
English
21