The Main Menu - Viscount Cantorum Trio Mode D'emploi

User Manual
o MANUAL III (Cantorum Trio): Manual III expression level;
o MANUAL II (Cantorum Duo): Manual II expression level;
NOTES
- When the instrument is switched on, its transposition value is set to zero.
- Transposition does not have any effect on playback of songs with the internal sequencer (unlike
recording, where the notes are acquired with the current transposition). A specific transposer is
provided for this purpose (see chapt. 8).
- If after the power on the system displays the error message "OP.SYS FAILURE PLEASE INSERT
USB PEN WITH RELEASE FILE", please insert the USB drive with the udpate file in the [USB]
connector under the manuals, then press [ENTER] and execute the update as described in the par.
5.12.
-
If after the power on the system displays the error message "RELESE CHECKSUM ERROR",
contact the technical support at service@viscount.it reporting the error type as it appears on the
second line (SYSTEM or MODEL) and the numbers in the "M:", "V:", "S:" and "Release" fields.
You will receive the files and information necessary to restore the instrument.
-
At power up, if you see the message "PERIPHERALS UPDATE REQUESTED", press [ENTER] to
perform the required operations to complete the update. If the message was displayed again contact
the technical support at service@viscount.it, specifying the information displayed.

3.1 THE MAIN MENU

The Main Menu contains several lower-level menus with all the settings of the instrument, divided into
groups.
Select the MAIN MENU field from the main video page. This page will appear:
As in the main video page the cursor is represented by the field with inverted colours. To move it, press the
buttons [FIELD ] and [FIELD ].
Here and in all the following video pages, some fields are used to access different pages. Select one of these
fields and press the [ENTER] button to access the corresponding page; when these fields are selected, the
name of the button appears on the right side of the field. Instead, when a field represents a parameter that
can be adjusted, the display shows the current value. To adjust a value, press the buttons [VALUE +] and
[VALUE -].
The fields of the MAIN MENU allow access to the following functions:
o SETTINGS: general instrument settings, equalizers, MIDI interface settings, audio outputs settings (rear
panel), factory settings reset and operating system update. These functions are described in chapter 5.
o STYLE: program organ Styles. This function is described in chap. 6.
o COMBIN. PRG (Combination Program Change): add Program Change and Bank Select MIDI messages
to combinations. This function is described in chap. 5.8.
o FILE: save and load files to and from an USB drive. Settings, Styles and combinations can be saved to an
external memory, the procedure is explained in chapter 7.
o DEMO: the instrument plays a demo song. This function is described in par. 10.1.
EN - 10