Viscount Cantorum Trio Mode D'emploi page 65

14. MIDI Pistons (Cantorum Trio only).
These controls, provided for each manual and the pedal board, allow transmission of the note MIDI
codes on the MIDI [OUT] port to be enabled and disabled. All the instrument's other MIDI messages
will continue to be transmitted, even with the MIDI control off.
15. General organ controls: these are the controls that are not dedicated to a single section, but affect the
whole instrument.
-
[MEM. BANK +] and [MEM. BANK -] (Cantorum Trio only): select the memory bank.
-
[A.P]: enables the Automatic Pedal which allows the pedal voices to be played on the Manual II
(Cantorum Trio) or Manual I (Cantorum I). In this case, the organ's pedal board is deactivated and
the voices become monophonic, with priority to the lowest note.
-
[ENC]: when the Enclosed function is active, the main volume can be controlled through the
expression pedal connected to the [EXPR.] connector ot the rear panel.
-
[C]: Cancel piston. Turns off all stops, tremulants, couplers and all other pistons on the manuals,
then deletes and turns on the HR. In case you have chosen to save into combinations the status of
MIDI pistons (Cantorum Trio only), [ENC] and [A.P] (see COMBINATIONS function in the par.
5.6), these are turned off by Cancel.
16. [PLENUM] piston: piston that recalls Plenum. The Plenum can be modified, for further information
read point 13.
17. [T] piston: piston that recalls Tutti. The Tutti can be modified, for further information read point 13.
18
18. [OUT 1] and [OUT 2] audio outputs: Jack line outputs with the organ stereo signal, based on the
settings of the video page described in par. 5.3. These outputs also has dedicated level and equalization
controls (see par. 4 and 5.2). In case of stereo system, connect the [L/MONO] output to the left channel
and the [RIGHT] output to the right channel. If a monophonic system is used, only connect the[L/
MONO] connector.
19. [PEDALS] connectors: in these connectors it is possibile to connect pedals to control the following
functions:
-
[SUSTAIN]: connector for a switch-type pedal to control the Sustain effect for orchestral voices.
-
[EXPR.]: continuous control of Man.III (Cantorum Trio) or Man.II (Cantorum II) volume.
-
[CRESC.]: With this pedal you can select the Crescendo level. These levels activate a fixed set of
stops, linked with an equal number of loudness, from pianissimo to fortissimo.
The currently selected level is displayed on the main video page inside the "CRESCEN." box.
The Crescendo controls all the registers, and modifies the stops configuration. Each level of the
crescendo can be programmed. To save the Crescendo configuration, see point 13.
20 22
19 21
EN - 7
User Manual
23 24 25