Operation; General; Thermostat Adjustment - Hatco Toast King Manuel D'installation Et D'utilisation

English

General

Hatco Toasters are designed for ease of operation. Perform the
following procedure to operate the toaster.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
2. Turn the Selector Switch from the OFF (O) position to the
TOaST or BUNS position.
NOTE: When toasting buns or bagels, place cut side facing out
and set the Selector Switch to the BUNS position.
3. Turn the Speed Control counter-clockwise to the
lightest/fastest position while the unit heats up.
NOTE: Allow approximately 20–30 minutes for a warm-up period.
CAUTION
Always operate toaster with toast collector pan installed.
BURN HAzARD: Some exterior surfaces on unit will get hot.
Use caution when touching these areas.
4. after warm-up period, set the Speed Control to the desired
toast darkness setting. The "1" setting on the Speed
Control knobs represents the lightest toast setting and the
"7" setting represents the darkest.
NOTE: To toast moist products such as English muffins, rye
bread, or whole wheat, slow the conveyor by turning
the Speed Control knob to a DARKER setting
(clockwise).
CAUTION
Toasting of coated or buttered products such as garlic
bread, cheese sandwiches, and sweet rolls is NOT
recommended. Residue will reduce toaster performance
and could ignite inside toaster. Using toaster with food
products listed above will void unit warranty.
Products thicker than 1-1/4" (32 mm) will cause conveyor
system to jam, which could ignite product inside toaster.
Form No. TRTKm-0816
Control Panel (TK-100 shown)
Manual Advance
The manual advance knob is located on the right side panel of
the toaster. This knob permits manual advancement of the
toasting baskets and allows rapid discharge of toast.

Thermostat Adjustment

The thermostat adjustment screw is located on the control
panel. The thermostat controls the toasting chamber
temperature and is preset at the factory.
If adjustment is needed, use the following procedure.
1. Turn the Selector Switch to the TOaST or BUNS position
and allow approximately 20–30 minutes for a warm-up
period.
• The thermostat should be adjusted when the toaster is
at the operation temperature.
2. Turn the adjustment screw using a small screwdriver.
• Turn the screw clockwise to increase temperature or
counterclockwise to decrease the temperature.
NOTE: Do not turn the screw more than 1/8 turn at a time.
Allow at least five minutes for temperature to stabilize.
9

OPERATION

Manual
Advance
Knob
Speed
Control
Thermostat
Adjustment
Screw
Selector
Switch