Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Toast too light.
Toast too dark.
Unit takes too long to toast.
Unit toasts on one side only.
(TK-135B and TK-155B models are
designed to toast one side of
buns/bagels only.)
Toaster trips the circuit breaker or
GFCI.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please
contact the nearest authorized Hatco Service agency or Hatco
for assistance. To locate the nearest Service agency, log onto
the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service
Team at:
Telephone: 800-558-0607 or 414-671-6350
e-mail:
partsandservice@hatcocorp.com
Form No. TRTKm-0816
Probable Cause
Speed Control set on a light setting.
Thermostat is set to low.
Supply voltage to unit is low.
Heating element defective.
Speed Control set on a dark setting.
Thermostat is set to high.
Supply voltage to unit is high.
The first few batches can take longer because the
toaster needs time to heat up when initially turned
on.
Supply voltage to unit is low.
The selector switch is in the BUNS position.
Heating element defective.
Circuit breaker is not sized properly for the
toaster.
Wiring fault inside toaster.
TROUBLESHOOTING GUIDE
ELECTRIC SHOCK HAzARD: Turn OFF power switch,
unplug power cord/turn off power at circuit breaker, and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
Turn Speed Control to a darker setting.
Refer
to
OPERaTION section for information.
Verify the supply voltage to the toaster matches the
unit specifications.
Contact authorized Service agent or Hatco for
assistance.
Turn Speed Control to a lighter setting.
Refer
to
OPERaTION section for information.
Verify the supply voltage to the toaster matches the
unit specifications.
Wait until the toaster is at full operation temperature
before inserting bread.
Verify the supply voltage to the toaster matches the
unit specifications.
move the selector switch to the BREaD position.
Contact authorized Service agent or Hatco for
assistance.
Check circuit breaker for proper sizing.
Contact authorized Service agent or Hatco for
assistance.
11
WARNING
Corrective Action
"Thermostat
adjustment"
"Thermostat
adjustment"
in
the
in
the
Publicité
Table des Matières
Dépannage
