Specifications; Plug Configurations - Hatco Toast King Manuel D'installation Et D'utilisation

English

Plug Configurations

Units are supplied from the factory with an electrical cord and
plug installed. Plugs are supplied according to the applications.
WARNING
ELECTRIC SHOCK HAzARD: Plug unit into a properly
grounded electrical receptacle of correct voltage, size, and
plug configuration. If plug and receptacle do not match,
contact a qualified electrician to determine and install
proper voltage and size electrical receptacle.
NOTE: Specification label located on the back of the unit. See
label for serial number and verification of unit electrical
information.
NEMA 6-20P
Plug Configurations
NOTE: Receptacles are not supplied by Hatco, but some are
available as accessories.
Form No. TRTKm-0816
Connecting Supply Wires
If local codes require Greenfield or conduit hook-up, consult a
licensed electrical contractor to perform supply wire connection.
access to the unit wiring is through the rear lower access panel.
To connect supply wires to the toaster:
NEMA 6-30P
5
1. Remove the screws securing the side panels, and remove
the side panels.
2. Remove the screws securing the rear lower access panel,
and remove the panel.
3. Insert the Greenfield or conduit through the opening in the
rear access panel and attach to the power supply bracket.
Connect the wires.
4. attach the ground wire to the power supply bracket at the
threaded hole marked "G".
5. Reinstall access panel and side panels.

SPECIFICATIONS